Alto-professional KICK15 Bedienungsanleitung PDF herunterladen (Seite 4)

REAR PANEL

1. POWER INPUT – Connect the included power cable to this input and connect the other

end of the cable to a power source. Make sure the top panel's POWER SWITCH is set to

"off" when plugging and unplugging the cable.

2. COOLING FAN – Keep the area in front of this vent clear from obstructions. The fan

behind the vent cools the amplifier, preventing overheating.

3. MIX OUT – Use standard balanced XLR cables

or balanced 1/4" mono TRS cables to connect

these outputs to the inputs of your active

loudspeakers.

4. SUB OUT – Use a standard balanced 1/4"

mono TRS cable to connect this output to the

input of an optional powered subwoofer.

5. LINK OUT – Use a standard unbalanced 1/4"

stereo TRS cable to connect this output to the

LINK IN of an optional second Kick amplifier (sold separately). When using this output, this

amplifier will be the "master"; it controls the audio, volume, etc. sent to the "slave" amplifier

connected to this output (each amplifier will output the same signal in parallel).

Alternatively, you may use a 1/4" stereo TRS splitter cable to connect this output to two

separate loudspeakers (left and right), two channels (left and right) of an external mixer,

etc.

6. LINK IN – Use a standard unbalanced 1/4" stereo TRS cable to connect this input to the

LINK OUT of an optional second Kick amplifier (sold separately). When using this input,

this amplifier will be the "slave"; its levels will be controlled by the "master" amplifier

connected to this input (each amplifier will output a summed mono signal).

7. MIC IN – Use a standard XLR cable to connect a microphone to this input.

8. LINE IN – Use standard 1/4" TRS cables to connect line-level instruments or sound

sources to these inputs. When connecting a mono sound source, use only the "L/MONO"

input.

9. AUX IN – Use a standard stereo RCA cable to connect a line-level sound source to these

inputs.

10. FOOT SW – You can connect a standard 1/4" TRS latching footswitch (sold separately) to

this input. A connected footswitch will allow you to activate/deactivate the amplifier's built-

in effects processor.

11. GROUND SWITCH – Depressing this switch grounds the amplifier, which can reduce hum

or noise.

Tip

(left channel)

Ring

(right channel)

Sleeve

(ground)

TRS connector

1 2 3 4 5 6 7 8 9 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Alto-professional KICK15 Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Akustik Alto-professional KICK15